How to Use Toyotube With Your Toyotomi Heater (Step-by-Step)
Follow these steps to correctly install and use Toyotube fuel cartridges on your Toyotomi (or Zibro) heater:
Step 1: Turn Off and Cool the Heater
Make sure your heater is switched off, unplugged and completely cooled down. Refueling a hot heater is dangerous due to the still warm components inside of the heater.
Step 2: Remove the Fuel Tank and Filter
Open the fuel compartment and carefully lift out the removable Toyotomi fuel tank. Place it on a flat surface with a cloth underneath to catch any drops and to make sure your surroundings stay clean. Locate the original fuel filter on the bottom of the heater inside. Remove it, this clears the way for the Toyotube adapter.
Step 3: Install the Toyotube Adapter
Insert the Toyotube adapter (red filter piece) in place of the old filter. Make sure it fits tightly and securely. This adapter is required for connecting Toyotube cartridges.
Step 4: Insert the Toyotube Cartridge
Take a sealed Toyotube cartridge and remove the cap and seal before using it, push it firmly into the adapter and turn it lock it into place, allowing clean fuel transfer into the heater tank without spills is done by using this system because the Toyotube will only give fuel when connected.
Step 5: Remove the Toyotube Cartridge
After the heater is fully refueled again you can safely remove the Toyotube Catridge even if there is still some fuel left into the Toyotube, due to the specifically designed cap it will not leak when being removed. If there is still fuel left in the cartridge you can store it and use it later when needed, otherwise you can safely throw the cartridge away which then can be recycled.
